Regulatory Information

This device complies with international standards for electromagnetic compatibility and safety, including CE, FCC, and RCM certifications.

CE Declaration of Conformity

Europe: European Conformity (CE) This device meets the requirements of the Radio Equipment Directive (RED) 2014/53/EU, the Electromagnetic Compatibility Directive (EMC) 2014/30/EU, and the Low Voltage Directive (LVD) 2014/35/EU.

It has been tested to and complies with the applicable harmonised standards for radio equipment, electromagnetic emissions and immunity, and electrical safety.

CE RED Cybersecurity

For products placed on the European market from August 2025, compliance also includes the applicable cybersecurity requirements for internet-connected radio equipment under the Radio Equipment Directive.

For these products, compliance includes the applicable cybersecurity requirements of RED Article 3(3):

  • Article 3(3)(d) - the radio equipment does not harm the network or its functioning, nor misuse network resources, thereby causing an unacceptable degradation of service.

  • Article 3(3)(e) - the radio equipment incorporates safeguards to ensure that the personal data and privacy of the user and subscriber are protected.

  • Article 3(3)(f) - the radio equipment supports features that ensure protection from fraud.

A full Declaration of Conformity (DoC) is available on request.

RCM Compliance

Australia and New Zealand: Regulatory Compliance Mark (RCM) This device complies with the applicable Australian and New Zealand radio communications and electrical safety requirements. It has been tested and meets the relevant ACMA and EESS standards for EMC and radiocommunications.

The RCM indicates that the product meets both electrical safety and electromagnetic compatibility requirements under the Australian Communications and Media Authority (ACMA) and other applicable national regulatory frameworks.

FCC statement

USA: Federal Communications Commission (FCC) statement

FCC ID: 2BCCIORBC3A

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference, including interference that may cause undesired operation of the device.

FCC Warning

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.

  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with the applicable FCC RF exposure requirements for an uncontrolled environment.

ISED Canada

Canada: Innovation, Science and Economic Development Canada (ISED)

IC: 36116-ORBC3A

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.

  2. This device must accept any interference, including interference that can cause undesired operation of the device.

French / Fran|ccedil|ais

L’émetteur ou le récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

  1. L’appareil ne doit pas produire de brouillage.

  2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

This device complies with ISED RSS-102 RF exposure limits for general public use (uncontrolled environment).

Accessing Regulatory Information

You can access the regulatory information for your device by following this link: https://portal.senquip.com/fcc.

Alternatively, you can view the device regulatory information on the Senquip Portal. To view the regulatory information:

  1. Launch the Senquip Portal.

Login to the Senquip Portal

  1. Browse to the device page

Navigate to device

  1. On the Device Info widget, select Regulatory Information

Select the regulatory information